There is hardly anything worse than waking up in the middle of a chilly winter night in a freezing house — except perhaps knowing you'll have a huge, costly furnace bill to pay later that day!
Don't be worried. You might be able to avoid pricey expert repairs (and hours-long wait periods) by troubleshooting and repairing your furnace yourself with a few do-it-yourself suggestions. You may be cuddling back beneath the blankets in a warm, cozy home in no time.
Furnace Repairing Expert in Brooklyn and Queens
Here are nine things to check before you call technician for your furnace repair in Brooklyn and Queens:
1. Make sure power and gas are activated
If you moved in during the summer and didn't require heat, it's likely that you neglected to set up your account. It's also possible that the issues are caused by a power outage. Before calling for help, double-check that your power and gas are both turned on.
2. Replace your batteries
Some thermostats are connected to the electrical system of your residential unit, while others run on batteries. If your thermostats are powered by batteries, consider replacing them with new ones. If the furnace kicks on, you've figured out what's wrong. Call in experts for furnace repair in Queens today!
3. Check your thermostat
Your furnace may appear to be blowing chilly air if your thermostat is not set to "HEAT." To be sure, flip the dial to 90 degrees, and then turn the system off for 30 seconds before turning it back on. This will reset some units.
4. Check your circuit breaker and emergency switch
If you see a breaker tripping in your home, you must reset it. If the breaker trips again, you should call your landlord or an electrician.
5. Replace the air filters
If your furnace isn't operating or appears feeble, it’s time to replace your air filter. Filters that are clogged are one of the most common causes of furnace problems. Newer furnaces may switch off even sooner, preventing further damage from overheating and shutting down.
6. Open the vents
Check to see if anything is blocking the vents in your home. A drape, piece of furniture, laundry basket, or box might be blocking the vent, causing disruption in heat flow.
7. Remove obstructions
A heating system might be suffocated by outdoor debris. Check out the area around the unit for any leaves, branches, or garbage that may have been pulled into the unit. As a general guideline, keep a three-foot radius around the unit free of bushes, plants, and other obstacles.
8. Check the pilot light
Because pilot lights may quickly blow out, many units will have special lighting instructions written on them. If you're not sure what's wrong, look up the manufacturer's instructions in your device or owner's handbook. If you're unsure, it's time to see an expert.
9. Know the age of your furnace
Furnaces can operate for a long time, but none of them can continue indefinitely. If your equipment has been out of warranty for a long time, it may be time for an update. Look for a service label on the device or information in your files that might indicate whether age is a contributing factor.
If you've gone through this easy checklist and are still having issues with your furnace, consider hiring a specialist to have it fixed. Whether you have Trane or Carrier, you can definitely benefit from it.